5 replies to this topic

[Valfar]

What can I do to play with GUI from BGT (with Elminster), not with this from TS.

Can you tell me how can I do it?

I've "GUI" mods like: SoS, TDD, CTB, TS and BGT

[SaKiS]

follow installation instractions they are pinned topic. Before installing BGT you have to uninstall (4 times) the GUI's of the large mods.

Edited by SaKiS, 03 February 2006 - 03:15 PM.

[Valfar]

As I remember, I've tried this already... but I'll try one more time

Edited by Valfar, 03 February 2006 - 03:30 PM.

[SaKiS]

when u install bgt if i remember correctly u will be asked what gui u want to use. if not run setup-gui and select elminister. gl

[cutecat]

May be you could refer to

http://www.shsforums...showtopic=18969

I had a similiar question, and Ascension64 explained it weey well.

Edited by cutecat, 03 February 2006 - 09:58 PM.

[Ascension64]

First, open up your WeiDU.log in your installation directory using a word processor. Check where in the list an entry that starts with "~SETUP-GUI.TP2~" is located. If this entry is above a line that starts with "~SETUP-BGT-MAIN.TP2~", then you can't do much about your TS GUI unless you re-install BGT-WeiDU. If the GUI line is below BGT-MAIN, then you can go to your <BGT-WeiDU installation directory> and run Setup-GUI.exe. Select the GUI you want. All mods that you installed after the GUI was installed will be re-installed. So you also be wary of big mods below the "~SETUP-GUI.TP2" line, such as DSotSC, NTotSC, and SoBH, if applicable.